ProTek RC Servo Lead & Terminal Crimping Tool
PTK-1999 ProTek RC Servo Lead & Terminal Crimping Tool

List Price: $22.25
Our Price: $19.99

Stock Status:In Stock

SKU: PTK-1999

The ProTek RC Servo Lead & Terminal Crimping Tool is the tool you need to make custom length signal wires for your ESCs, receiver batteries and servos. This tool safely secures the connector pins on wire sizes between 14 and 28awg, without damaging the pin or the wire. Simply strip a short length of the shielding off the wires, install the connector pin into the tool, insert the wire into the pin, and squeeze the tool to crimp the pin in place.

Want more? Unlike most terminal crimping tools, the ProTek tool will allow you to strip 12, 16 and 22awg wire, and includes a cutter as well. Crimps 20, 24 and 28 AWG wire.

NOTE: When changing the length of your signal wires or receiver battery connectors, for the best results we recommend you use new connectors.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 June 6, 2019
Reviewer: Dan Collinsworth from Gilbert, AZ United States  

Was this review helpful to you?